Sand dryer is also known as the three layers of drum dryer, three return cylinder dryer, on the basis of the single-cylinder dryer, developed and manufactured, which is an industrial dryer on non-viscous, liquid material. At present three-cylinder dryer made by Dingli company, with mature technology, through the drying of the sand, fly ash, coal, mineral materials, slag and other material, the effect is very good.
The first step in the processing of sand, gravel, and aggregates after mining is a washing and classification process. The material may be screened and stored but at some point moisture content needs to be reduced to meet a specification required for the sale or further processing. Large-scale sand drum dryers can be used for the dehydration drying and upgrading equipment of high-humidity wastes such as quartz sand, slag, bentonite, kaolin, etc. Low drying cost, mature technology, large reserves, simple operation, low manpower requirements.
The sand is conveyed to silo by belt conveyor or bucket elevator, and transport to the feed end by the feeder of the silo . The inclination of the feeding pipeline should exceed the natural inclination of materials so that to facilitate sand flowing into the dryer smoothly. The rotating cylinder of the dryer is slightly inclined to the horizon. To feed the material from the higher end and the heat carrier enter from the lower end, such produce adverse contact between them .sometimes, they can be fed to the cylinder together. As the cylinder running, the sand carried to the lower side by the gravity. In the process of moving forward, the wet raw material being roasted by the heat directly or indirectly to make the raw material to dry quickly, the final products discharge out by belt conveyor or screw conveyor. There is a shoveling plate installed in the dryer with the function of shoveling the materials up and down, to enlarge the contact area between airflow and materials and to enhance the efficiency and make the material running quickly. The heat carrier is hot air, the flue gas, etc. After the dryer process, It needs a cyclone dust collector to catch the items in the airflow. You should use a bag type or wet-type dust collector and afterward discharge the waste gas if you intend to further reduce the dust load of the exhaust.
Model (m) | Capacity (T/H) | Coal consumption kg/t | Total power | ||
---|---|---|---|---|---|
Φ2.0×5 | 12-15 | 10-12 | 4kw×2 | ||
Φ2.2×5 | 14-18 | 10-12 | 5.5kw×2 | ||
Φ2.5×5 | 23-28 | 10-12 | 5.5kw×4 | ||
Φ2.8×6 | 30-35 | 10-12 | 5.5kw×4 | ||
Φ3.0×6 | 35-40 | 8-10 | 7.5kw×4 | ||
Φ3.0×7 | 40-45 | 8-10 | 7.5kw×4 | ||
Φ3.2×7 | 45-50 | 8-10 | 11kw×4 | ||
Φ3.2×8 | 50-55 | 8-10 | 11kw×4 | ||
Φ3.6×8 | 60-70 | 6-8 | 15kw×4 | ||
Φ3.8×9 | 70-80 | 6-8 | 15kw×4 | ||
Φ4.0×10 | 90-100 | 6-8 | 18.5kw×4 | ||
Φ4.2×8.5 | 80-100 | 6-8 | 18.5kw×4 | ||
(The output is set according to moisture : dry from 15% to 1-3%) |